I received a recall notice from MonotaRO, where I purchased my front brake pads.
It seems that the product I purchased last time contained a few percent asbestos.
I received a replacement and return kit.
It was quite thorough, containing a dust mask, plastic bags for airtight packaging, and even old newspapers to wet and wrap the pads in to prevent dust from flying.
Since it’s apparently to prevent health hazards, I replaced them straight away.
These are the replacement pads I purchased.
Miyaco MD-320, 1 set (4 pads)
They were ¥2,594 (tax included) at MonotaRO.
Another commemorative (record) photo of the new pad.
I jacked up the right front end and removed the caliper.
A close-up of the brakes.
I tried to look at the pad’s serial number, but it had been obscured by the grease.
I wasn’t sure if it was the affected part, so I called to inquire, and was told that in that case I should just replace it, so I ended up replacing it.
This is a commemorative (record) photo of the new pad.
The replacement was successful.
I did the same on the left side, but I’m tired so I don’t have any photos. (^_^;)
The procedure is the same as last time, so please refer to “Front brake pad replacement, GD-TT2″(https://solaristyka.com/en/diy-mech-workshop-en/subaru-samber-en/front-brake-pad-replacement-en/).
Mileage: Forgot to record (about 51,600 km)
Comments